Body Cryotherapy chamber

Total body cryotherapy chamber consisting of the following separate basic parts, which are presented together and unassembled : 1) Cryotherapy Chamber consisting of a Pre-Chamber (minus 60 °C) and a Therapy Chamber (approximately minus 110 °C) which are connected by a door.

The Cryotherapy Chamber is made up of insulating elements. The external dimensions of the Chamber are 2400 mm (W) x 4200 mm (L) x 2550 mm (H). The internal dimensions of the Pre-Chamber are 1600 mm (W) x 2250 mm (H) x 1760 mm (D) and of the Therapy Chamber are 2100 mm (W) x 2250 mm (H) x 1700 mm (D). Both the Pre-Chamber and the Therapy Chamber are equipped with a special water-resistant carpet on the floor, entrance doors, windows, lighting, load speakers, emergency signal switches, pressure balance elements, and with evaporators. The evaporators have built-in three fans enabling the air circulation and integrated defrost-heating device. The Therapy Chamber is further equipped with a microphone and a video monitoring system. 2) Refrigeration machine. The refrigerating machine is a 3-level cascade system installed in closed machine housing, and it is air cooled. The machine is placed in another room than the Cryotherapy Chamber, and together with the evaporator, it creates temperature in the Chamber up to -110 °C. The dimensions of the refrigerating machine are 1600 mm (W) x 1700 mm (H) x 800 mm (D). 3) Switching cabinet. The switching cabinet incorporates electric switching system which is necessary for operating the Total Body Cryotherapy Chamber as a whole. The cabinet is placed in the same room as the above mentioned refrigerating machine. Its dimensions are 1000 mm (W) x 2000 mm (H) x 500 mm (D).

4) Control desk. The control desk includes industry PC embedded nanoservers, a 15’’ TFT display with touch screen, an inter phone, two loudspeakers, a microphone, a CD player and an emergency stop switch. All these components are built in the same housing. Over the touch screen, an operator can control all functions, adjustments and machines values. The desk has dimensions of 600 mm (W) x 980 mm (H) x 400 mm (D) and is placed in the same room as the Cryotherapic Chamber. 5) Condenser. The condenser consists of a heat exchanger with crossing twin ribs and ventilators with three-phase motors. The condenser is located outside the building where the Cryotherapy Chamber is established and it is involved in the creation of the low temperature in the chamber. All above-mentioned units are connected by copper tubes, through which the coolant circulates, and by electrical cable

Classification: 9018.90.

HS codes considered: 84.18 and 90.18.

Classification Rationale: GIRs 1 (Note 3 to Chapter 90 and Note 4 to Section XVI) and 6.

Cesar Olivier Dalston, www.dalston.com.br. 

Source: The Harmonized System Committee (49 th Session – March 2012).